Fluke 375 Calibration

$125.00

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Component-level Fluke 375 repair backed by a 90-day warranty. We restore full performance for calibration interval and accreditation functions.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Category: Fluke Calibration Tags: 375, 90 day warranty, authorized repair, cal service, calibration service, certified service, fast turnaround, Fluke, Fluke 375, Fluke calibration, June Company, loaner available, metrology, near me, NIST calibration, NIST traceable, service center

Description

Fluke 375 Calibration

The Fluke 375 is a clamp meter, which is calibrated differently from a bench instrument because the measurement depends on a magnetic circuit. Jaw alignment, jaw wear and where the conductor sits inside the opening all affect the reading, so verification has to account for the jaws and not only the electronics behind them.

June Company calibrates the Fluke 375 for electricians, industrial maintenance teams, HVAC technicians, and energy auditors. Every point is measured against reference standards, with as-found readings recorded before any adjustment and as-left readings afterwards, so you can see what condition the instrument was actually in when it arrived.

What we verify on the Fluke 375

AC current across all ranges, at several positions in the jaw.
DC current on models with Hall-effect sensing.
Jaw alignment and closure – a gap or a worn mating face changes the reading before any electronics are involved.
Voltage and resistance functions where fitted.
Inrush and peak capture where fitted.
Frequency and power measurement on the advanced models.

FAQs

What happens if it comes back out of tolerance? We record the as-found condition and tell you, because measurements you took with it since its last calibration may need reviewing. That is the reason as-found data matters.

Can it be adjusted if it has drifted? Where the instrument supports adjustment, yes – and the as-found and as-left readings are both recorded so the change is visible.

Calibration is documented and returned with the instrument. If we find a fault that calibration cannot correct, we quote the repair before going any further. Email us or submit a service request.