Status: 8808A / 8845A / 8846A Current Production — 45 Discontinued. We repair and calibrate all of them.
Common Fluke Bench Multimeter Problems We Fix
- Blown input / no reading after an overvoltage
- Inaccurate readings or drift out of tolerance
- Dead or faded display / backlight or pixel failure
- Won’t power on or measurement noise on the readings
- Won’t communicate over GPIB / RS-232 / USB (ATE integration fails)
- Front/rear input switching not working
- 2-wire / 4-wire resistance reading wrong
- Relay switching faults from high-volume production testing
Don’t see your exact problem? We repair all Fluke bench DMM faults — email us and describe what’s happening.
Fluke Bench Multimeter Models We Service
| Model | Description | Service |
|---|---|---|
| Fluke 8846A | 6.5-digit bench DMM with graphical display and trend plot | Repair & Calibration |
| Fluke 8845A | 6.5-digit bench DMM with numeric display | Repair & Calibration |
| Fluke 8808A | 5.5-digit bench DMM for production test | Repair & Calibration |
| Fluke 45 | Dual-display bench multimeter (legacy) | Repair & Calibration |
How to Send In Your Fluke Bench Multimeter
- Tell us what’s wrong. Email us or submit a service request with your model and the problem.
- Ship it to us. Send your unit from anywhere in the US — we provide prepaid shipping labels on request.
- Get a firm quote. We evaluate it and send a no-obligation repair quote. No work is done until you approve.
Email: info@junecompany.com | All repairs include NIST-traceable calibration and a 90-day parts-and-labor warranty.
Frequently Asked Questions
How much does Fluke bench multimeter repair cost?
Repairs start with a flat evaluation fee that’s credited toward your repair cost. After we diagnose the unit, you get a firm quote before any work begins — no surprises.
How long does the repair take?
Most Fluke 45, 8808A, 8845A, and 8846A repairs are finished within 5–10 business days of arrival, with expedited turnaround available if your bench is down.
My bench DMM has drifted out of tolerance — can you bring it back into spec?
Yes. ADC reference drift that pushes a 6.5- or 5.5-digit meter out of tolerance is a common repair. We correct the cause and verify accuracy against our reference standards.
Do you still repair the legacy Fluke 45?
Yes. The dual-display Fluke 45 is discontinued but fully supported for repair and recalibration — display and input faults on these older benches are routine for us.
Can you fix GPIB/RS-232/USB faults that break automated test?
Yes. Interface board failures that stop GPIB, RS-232, or USB control are a common repair, restored so the meter rejoins your automated test system.
Just need calibration, not a repair?
We do both. If your bench DMM works but is due for recalibration, we provide NIST-traceable calibration with a documented certificate against the manufacturer’s published specifications.
What if my exact model isn’t listed?
We service every Fluke bench DMM configuration. If your model isn’t in the table, pick the closest match or email us — the process is the same.
Who uses Fluke bench multimeters?
Calibration labs, electronics manufacturers, production test facilities, R&D engineering, and automated test systems rely on the 45, 8808A, 8845A, and 8846A for laboratory-grade bench measurements.
See also our Fluke 180 Series repair, Fluke 80V Series repair, and Fluke 280 Series repair pages, or browse all multimeter repair services.
