Fluke 7320 Calibration Bath Repair

$245.00

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Full-service Fluke Calibration Bath 7320 repair: diagnostics, component replacement, and recalibration. Our technicians specialize in heating element replacement, stirrer mechanism rebuild, controller board repair, and temperature uniformity verification.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Description

Fluke 7320 Calibration Bath Repair

The Fluke 7320 is a stirred-liquid calibration bath – probes are immersed directly in a circulating fluid, and that circulation is what delivers the uniformity a dry block cannot match. The stirrer is therefore not an accessory but the core of how the instrument works, and the fluid itself is a consumable that degrades.

Certified technicians at June Company service the Fluke 7320 for calibration laboratories, metrology departments, standards labs, and instrument workshops. Every instrument is repaired at component level and verified against reference standards before it ships back, with the measured results documented.

Common Fluke 7320 problems we fix

Stirrer motor failing, noisy, or not circulating – the fault unique to a bath and the most consequential – without proper circulation the fluid stratifies and uniformity collapses, even though the display still reports a perfectly steady temperature.
Uniformity or stability outside specification.
Heater element failure.
Refrigeration not pulling down to low setpoints – the cooling system on the low-temperature baths, which is a separate subsystem from the heater.
Temperature unstable or overshooting setpoint – the control loop – a source that will not settle cannot be used for calibration at all, however accurate its readout claims to be.
Fluid contaminated or degraded – bath fluid is a consumable – once it has broken down it changes both the heat transfer and the achievable range.
Leaks, seals, or level sensor faults.
Display, keypad or interface faults.
Serial, USB or remote-control communication failures – which breaks automated calibration sequences while the instrument still works manually.