Fluke 190-104-III Scopemeter Repair

$245.00

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Get your Fluke Scopemeter 190-104-III repaired with certified accuracy and a 90-day warranty. Trusted by industrial electricians, automation technicians, field service engineers, and maintenance troubleshooters nationwide.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Description

Fluke 190-104-III Scopemeter Repair

The Fluke 190-104-III is a ScopeMeter Test Tool from the 190 series – the line built around independently isolated inputs. Each channel floats separately, which is the entire reason these instruments get bought for motor drives, power electronics and three-phase work where two probes sharing a ground would short something expensive together. This model is the 100 MHz, four-channel configuration, so its front-end and timebase are specified accordingly and are verified to that bandwidth after repair. Four isolated channels is the configuration bought for three-phase and drive work, where the channel count is the whole point.

June Company’s certified technicians repair the Fluke 190-104-III for field service engineers, drive and motor technicians, power electronics engineers, and industrial maintenance teams. Every instrument is repaired at component level and verified against reference standards before it ships back, with the measured results documented.

Common Fluke 190-104-III problems we fix

Will not power on or hold charge – the battery pack and the charging circuit, tested separately since either can present as a dead instrument.
Keypad or rotary control unresponsive.
Measurements drifted out of tolerance – the measurement path, corrected and verified against reference standards.
Ruggedised case seals and connectors damaged.
Isolation between channels compromised – the fault specific to this series and the most important one to catch – a 190 with a degraded isolation barrier still displays waveforms perfectly while no longer being safe for the floating measurements it was bought for.
Channel dead, noisy, or reading inaccurately – input front-end damage, almost always from an over-range or transient input, repaired at component level and the channel re-verified.
Waveform will not trigger or hold steady – the trigger circuit, which is what turns a scope into an unusable one while every other function still appears to work.
Display failure – blank, dim, or degraded LCD – on the older ScopeMeters this often shows as banding or a faded centre before it fails outright.

FAQs

How long does a repair take? Most are completed in 5-10 business days, with a firm quote after evaluation and before any work begins.

How do I know the input isolation is still intact? You cannot tell from the screen, which is the danger – a unit with degraded isolation looks completely normal. We test the barrier directly as part of every 190-series repair.

Every repair carries a 90-day parts-and-labor warranty, with a firm quote before any work begins. Email us or submit a service request.