Fluke MDA-510 Motor Drive Analyzer Repair

$245.00

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Expert repair and calibration with documented test results. Our technicians specialize in input protection restoration, ADC board repair, probe interface recalibration, and Class A compliance verification.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Category: Fluke Power Quality Analyzer Repair Tags: MDA-510, motor diagnostics, motor drive analyzer, variable frequency drive, VFD tester

Description

Fluke MDA-510 Motor Drive Analyzer Repair

The Fluke MDA-510 is a motor drive analyzer – a specialised instrument for variable frequency drives, measuring the voltage modulation, shaft voltage and dV/dt stress that a general-purpose meter cannot capture. Drives destroy bearings and windings through mechanisms that only show up in these measurements.

June Company’s certified technicians repair the Fluke MDA-510 for drive technicians, motor shops, industrial maintenance teams, and predictive maintenance programs. Every instrument is repaired at component level and verified against reference standards before it ships back, with the measured results documented.

Common Fluke MDA-510 problems we fix

Shaft voltage measurement not reading – the input dedicated to detecting bearing-damaging discharge, which is the specific reason this instrument exists.
dV/dt or rise-time capture failing.
Voltage or current channel dead.
Guided-measurement sequences not completing.
Memory or report generation faults.
Battery, charging or power faults.
Display, keypad or interface faults.

FAQs

How long does a repair take? Most are completed in 5-10 business days, with a firm quote after evaluation and before any work starts.

Shaft voltage reads zero but I can see bearing damage. Instrument or setup? Worth checking the instrument. That input is easily damaged and a dead channel reads as a clean result, which is the worst possible failure mode here.

Every repair carries a 90-day parts-and-labor warranty, with a firm quote before any work begins. Email us or submit a service request.