Sale!

Fluke CERTIFIBER PRO Calibration

Original price was: $425.00.Current price is: $385.00.

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Factory-level Fluke CERTIFIBER PRO repair with NIST-traceable calibration. Our technicians specialize in reference source adjustment, DAC replacement, sensor recalibration, and full performance verification with traceable standards.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Category: Fluke Calibration Tags: 90 day warranty, authorized repair, cal service, calibration service, CertiFiber Pro, certified service, fast turnaround, Fluke, Fluke calibration, Fluke CertiFiber Pro, June Company, loaner available, metrology, near me, NIST calibration, NIST traceable, service center

Description

Fluke CERTIFIBER PRO Calibration

The Fluke CERTIFIBER PRO is a fiber optic test set, where the calibration has to cover the optical side as well as the electronics. Power measurement accuracy is wavelength-dependent, so a meter correct at 1310 nm can be out at 1550 nm, and a single-wavelength check would never reveal it.

Calibration of the Fluke CERTIFIBER PRO is performed at June Company for fiber optic installers, network engineers, data centre technicians, and telecommunications crews. Every point is measured against reference standards, with as-found readings recorded before any adjustment and as-left readings afterwards, so you can see what condition the instrument was actually in when it arrived.

What we verify on the Fluke CERTIFIBER PRO

Loss measurement and referencing.
OTDR distance and event-location accuracy where fitted.
Optical connector endface condition.
Adapter and launch cord condition.
Optical power measurement at each supported wavelength – accuracy is wavelength-specific and does not transfer between them.
Source output power and stability.

FAQs

Is the calibration traceable? Yes. Every point is measured against reference standards and the results are documented and returned with the instrument.

What if you find a fault during calibration? We stop and quote. There is no point adjusting an instrument that has a hardware fault, so you decide before any repair work begins.

Calibration is documented and returned with the instrument. If we find a fault that calibration cannot correct, we quote the repair before going any further. Email us or submit a service request.