Fluke CertiFiber Pro Repair

$245.00

🛡️ 90-Day Warranty ✓ Fee Credited to Repair ⚡ No Forms Needed

Certified Fluke Networks Meter & Calibration repair — fast turnaround, 90-day warranty included. Critical for fiber optic installers, network engineers, data center technicians, and CATV technicians who depend on reliable certifiber pro performance.

Helpful Resources

📋 How It Works

Submit Request – Pay evaluation fee & provide equipment details
Ship to Us – Send your equipment to our Oregon facility
We Evaluate – Detailed diagnosis & repair estimate
Fee Credited – Your evaluation fee applies to repair cost
We Repair – Professional repair with 90-day warranty

🔧 Fast Turnaround: Most repairs are completed within 1–3 business days.
📏 Precision Calibration: NIST-traceable calibrations included for most repairs.
🛡️ Warranty: 90-day warranty on all repairs.
📝 Transparency: Detailed evaluation and repair estimate before work begins.

✓ Evaluation Fee Credited Toward Repair

This evaluation fee is applied as credit toward your final repair cost. After we evaluate your equipment, you'll receive a detailed estimate before any repair work begins.

Description

Fluke CertiFiber Pro Repair

The Fluke CertiFiber Pro is a fiber optic test instrument – it measures optical loss, and in the OTDR models locates faults along the fiber by timing backscattered light. Everything depends on the optical ports being clean and undamaged, because a contaminated endface changes the measurement before any electronics are involved.

June Company’s certified technicians repair the Fluke CertiFiber Pro for fiber optic installers, network engineers, data centre technicians, and telecommunications crews. Every instrument is repaired at component level and verified against reference standards before it ships back, with the measured results documented.

Common Fluke CertiFiber Pro problems we fix

Connector adapters worn.
Output or measurement drifted out of tolerance – corrected and verified against reference standards.
Display, keypad or interface faults.
Battery, charging or power faults.
Optical port contaminated or damaged – the endface itself – the commonest cause of results that look like a bad link when the link is fine.
Laser source output degraded or unstable.
Detector calibration drifted.
OTDR launch or dead-zone performance degraded.

FAQs

Every fiber I test now reads high loss. Instrument or my fibers? Almost always the instrument’s optical port. Contamination or endface damage adds loss to every single measurement, which is the giveaway.

Is the laser source repairable or is that the end of the instrument? Usually repairable. Source degradation is a known wear mechanism rather than a terminal fault.

Every repair carries a 90-day parts-and-labor warranty, with a firm quote before any work begins. Email us or submit a service request.